Today, Zhongtao Jun will come to Amway to teach you How to use ceramic tile adhesive. This is not like the comments you see when scrolling through Douyin: you will know it at a glance. Once you do it, it will be like this! There is nothing more suitable than a laughing and crying emoticon.
First of all, when laying tiles, we often need auxiliary materials such as tile glue. It is widely used in building decoration. It is favored by people because of its beautiful and elegant appearance. Tile adhesive can also be said to be a substitute for cement. Its adhesion is very strong. It can not only stick tiles firmly, but also be used for Installation of plasterboard and fibreboard etc.
How to use tile adhesive? Let us take this question and follow Zhongtaojun to learn how to use tile adhesive!
How to use tile adhesive
1. Preparation tools
Before construction, we need to prepare the required materials to ensure that the construction proceeds smoothly and efficiently. The specific tools are as follows: tile glue, electric mixer, spatula, toothed scraper, sturdy plastic bucket, level, plastic cross, glue hammer, etc.
2. Base surface cleaning
After the tools are ready, we need to clean the base surface. The requirement for the base surface is that it should be smooth and solid, without sand, cracks, scratches, uneven unevenness, and dust, stains, etc. If the base surface is uneven and has stains, it is recommended that you use Knorrbond interface agent, putty powder, etc. to apply glue (loose base surface), roughen (smooth base surface) or level it.
3. Add water and stir evenly
WhenAfter the base surface is cleaned, we need to mix it with clean water in a certain proportion. The order of addition is: liquid first and then powder. The specific ratio is: tile adhesive and water according to the ratio of 20kg: 4.4-4.8L. Then we use an electric mixer to stir evenly until it becomes a paste without particles, and then let it sit for 10 minutes until it is fully matured, then stir it again and then it can be used normally. For the evenly stirred slurry, it is recommended that you use it within 2-3 hours.
4. Large-area construction
After it is mixed evenly, we need to spray the base surface with water. It must be completely wet but there should be no open water. After that, we use a toothed scraper to evenly apply the tile adhesive on the wall and the back of the tiles. During the scraping process, we must ensure that the angle of the toothed scraper and the base surface is consistent. Apply about 1-2 square meters each time, and then start from the bottom Just knead and press the tiles on, and then make fine adjustments within 15 minutes.
We must know that tiling is a delicate job, so we must follow its construction standards and steps during construction, so that we can have better construction quality and better durability. To avoid hollow drums and other phenomena during later use. The above is the method of using tile adhesive explained by the editor of Baoman.
How to use tile adhesiveHave you learned it? If you decorate your own home, you might as well try these steps yourself. Well, that’s it for today’s sharing. Mr. Zhongtao will leave first. Otherwise, you should trouble me if you don’t learn!
